10 Dismounting and decommissioning
When the control unit has reached the end of its service life it must
be dismounted and disposed of in an environmentally responsible
manner.
Personnel:
n
Qualified personnel
1. Ensure that the machine connected to the control unit rests in
a safe state.
2. Disable the external power supply.
3. Disconnect the power supply cable.
4. Disconnect all input, output and interface wiring.
5. Secure the control unit against unwanted movement.
6. Loosen the screws that fix the control unit inside the cabinet.
7. Dismount the control unit.
Electronic components are considered special waste. They must
be properly disposed of.
Power Automation will accept the control unit to properly dispose of
its components upon decommissioning.
To return the control unit follow the instructions given
in
Ä
Chapter 9.3 “Return policy and procedure”
on page 97.
CAUTION!
Environmental hazard caused by incorrect han-
dling!
Incorrect handling of environmentally hazardous sub-
stances, especially incorrect waste disposal, can
cause considerable damage to the environment.
Dismounting
Decommissioning
PA 8000 EL CNC control unit
Dismounting and decommissioning
24.09.2015 | 101
To Next Page
Loading...