power automation PA 8000 EL User Manual

2.4 Unintended use
WARNING!
Beware of unintended use!
– In particular, avoid using the control unit for the fol-
lowing purposes as these are regarded as not
intended:
– Operation using software not approved by
Power Automation.
– Operation connected to machines/drives not
deemed compatible by Power Automation.
– Operation using wrong number of axes
– Wrong or missing execution of the mainte-
nance intervals
– Operation by not instructed personnel
2.5 Personal protective gear
Wearing of personal protective gear is required to minimize health
hazards and damage when working with the control unit.
n Always wear the protective equipment that is necessary for the
respective task when working.
n Follow the instructions on personal protective equipment that
are listed in this installation manual and other installation man-
uals provided by Power Automation.
n The environment in which the control unit is installed may
require users to wear additional personal protective gear.
Observe the instructions on personal protective gear provided
by the operating company.
Antistatic gloves
for protection of the hands during the work. Wear the antistatic
gloves always until the work is finished.
ESD clothing
for protection of components susceptible to electrostatic discharge.
Wear the ESD clothing during the work on electrostatic compo-
nents.
ESD safety pad
for protection of components susceptible to electrostatic discharge.
Put the ESD safety pad on the floor before starting to work.
ESD safety shoes
for protection of components susceptible to electrostatic discharge.
Wear the ESD safety shoes to protect electrostatic-discharge-sen-
sitive devices due to inadequate derivative electrostatic energy.
Unintended Use
PA 8000 EL CNC control unit
Safety
24.09.2015 | 14

power automation PA 8000 EL Specifications

General

Brand	power automation
Model	PA 8000 EL
Category	Control Unit
Language	English