Electronic components are considered special waste. They must
be properly disposed of.
Power Automation will accept the control unit to properly dispose of
its components upon decommissioning.
n Follow the standard return procedure, as described in
Ä
Chapter 9.3 “Return policy and procedure” on page 97.
2.12 Labels
The following labels are attached to the control unit.
NOTICE!
Readability Of Labels
Over the course of time labels may become dirty or
nonreadable for any other reason. Improper input vol-
tages applied due to readability of labels can damage
the control unit.
– Keep labels in readable condition at all times.
– Replace damaged labels (not including material
warranty seals).
– Replacements can be obtained from
Power Automation.
The labels listed hereunder are located on the top side (PC con-
nector side) of the control unit (Fig. 3).
Fig. 3: Control unit top side
Electronic Components
Overview
PA 8000 EL CNC control unit
Safety
24.09.2015 | 23
To Next Page
Loading...