power automation PA 8000 EL - Default Chapter; Table of Contents

Table of contents
1 General information............................................................. 7
1.1 Information on this manual.......................................... 7
1.2 Explanation of symbols................................................ 7
1.3 Limitation of liability...................................................... 9
1.4 Copyright..................................................................... 9
1.5 Warranty terms............................................................ 9
1.6 Customer service....................................................... 10
1.7 Glossary..................................................................... 10
2 Safety.................................................................................. 11
2.1 Customer's responsibility........................................... 11
2.2 Personnel requirements............................................. 12
2.2.1 Qualifications........................................................... 12
2.2.2 Unauthorized persons............................................. 12
2.3 Intended use.............................................................. 13
2.4 Unintended use.......................................................... 14
2.5 Personal protective gear............................................ 14
2.6 Specific dangers........................................................ 15
2.7 Safety devices........................................................... 17
2.8 Machine safety........................................................... 17
2.8.1 'CNC ready' signal - Emergency stop interlocking.. 18
2.8.2 'Power ok' signal..................................................... 19
2.9 Conduct in a dangerous situation and in case of
accidents.................................................................... 19
2.10 Data safety................................................................. 20
2.10.1 File backup.............................................................. 20
2.10.2 System protection................................................... 20
2.11 Environmental protection........................................... 22
2.12 Labels........................................................................ 23
3 Design and function.......................................................... 27
3.1 Overview.................................................................... 27
3.2 Brief description......................................................... 27
3.3 Module 2416 EL......................................................... 28
3.3.1 Digital inputs............................................................ 29
3.3.1.1 Input interfaces..................................................... 29
3.3.1.2 Input characteristics.............................................. 33
3.3.1.3 Input schematic.................................................... 34
PA 8000 EL CNC control unit
Table of contents
24.09.2015 | 3