Why are the analog outputs set to 0V on my power automation PA 8000?
If the CNC is not ready, the power supply for the RMS is outside the tolerated values, or the ambient temperature exceeds 55 °C (131 °F), the analog outputs are set to 0V. Verify the CNC readiness and power supply values to resolve this issue with your power automation Control Unit.
What to do if ambient temperature is too high for power automation PA 8000?
If the ambient temperature is above 60 °C (140 °F), all outputs are disabled by the onboard logic. Allow the module to cool down to resolve this issue with your power automation Control Unit.
General| Brand | power automation |
|---|---|
| Model | PA 8000 |
| Category | Control Unit |
| Language | English |
Defines the user's obligations regarding industrial safety, accident prevention, and environmental protection.
Specifies qualifications and requirements for personnel operating the control unit safely.
Details the necessary personal protective equipment (PPE) for safe operation and handling.
Identifies residual risks and specific hazards associated with the control unit's operation.
Explains the importance and proper integration of safety devices within the PAMIO system.
Covers safety aspects related to machine operation, including emergency stop interlocking.
Provides guidelines for emergency response and actions to take in case of accidents.
Details the physical mounting and installation procedures for PAMIO components, including DIN rail mounting.
Outlines safety precautions that must be followed during troubleshooting procedures.
To Next Page
