2 Safety
2.1 Customer's responsibility
The control unit is used for commercial purposes. The operating
company is thus subject to the legal obligations concerning indus-
trial safety.
The safety, accident prevention and environmental protection regu-
lations applicable for the area of application of the machine must
be complied with, along with the safety notes specified in this
installation manual. The following applies in particular:
n The customer must become familiar with the industrial safety
regulations and identify additional dangers which may arise
due to the specific working conditions at the place of use of the
control unit, by means of a risk analysis. These must be con-
verted into operating instructions for operation of the control
unit.
n Throughout the time of use of the control unit the customer
must check whether the operating instructions created by him
correspond to the current status of regulations and standards.
Whenever changes in regulations and standards occur, instruc-
tions must be adapted accordingly.
n The customer must clearly specify the responsibilities for
installation, operation, maintenance, and cleaning.
n The customer must make sure that all employees who have to
work with the control unit have read and understood these
operating instructions.
In addition, the customer must train and inform his personnel
about potential dangers at regular intervals.
Moreover, the customer is also responsible for keeping the control
unit in technically good condition, and therefore the following
applies:
n The customer must make sure that the maintenance intervals
specified in these operating instructions are complied with.
n The customer must regularly check all safety features for func-
tion and completeness.
n The customer must supply his personnel with the necessary
protective equipment.
PA 8000 PAMIO
Safety
12.01.2017 | 11
To Next Page
Loading...
Need help?
General
