power automation PA 8000 - Digital Inputs

4.4.2.1 Digital Inputs
Fig. 28: PAMIO 2416 inputs
5 Input byte 3 (X47)
6 Input byte 2 (X46)
7 Input byte 1 (X45)
n Each byte is connected with an 8 pole terminal block (Fig. 29).
n The conductor cross-section of the wire must be 0.3 to 1.75
mm
2
(AWG 22 to 15).
n The inputs are always referenced against 0 V, located in the
power connector (X30 pin 3).
Fig. 29: Input terminal block
Connection
PA 8000 PAMIO
PAMIO Components
12.01.2017 | 54