power automation PA 8000 - PAMIO On-Board Logic Power Supply

Superbus cables are available as options from
Power Automation (see Ä Chapter 6.1.1 “Service
addresses” on page 130).
Ordering code: see
Ä “Available Superbus Cables”
on page 47
Length in m Length in ft Ordering code
0.5 1.6 CAB PAMIO 0.5
2 6.5 CAB PAMIO 2
5 16.5 CAB PAMIO 5
10 33 CAB PAMIO 10
20 66 CAB PAMIO 20
25 82 CAB PAMIO 25
The PAMIO cable (0.5m / 1.6 ft) is only usable with
a PAMIO box mounted on the left side of the CNC.
4.3.2 PAMIO On-Board Logic Power Supply
Every PAMIO module requires a 24V DC power supply for its On-
Board logic. The backplane in which the module is mounted is sup-
plied as well from this input.
Depending on the model, there can be more than one power
supply connector on a PAMIO module. But all models use he same
connector X30 for the On-Board logic power supply.
Available Superbus Cables
On-Board Logic Power Supply
PA 8000 PAMIO
PAMIO Components
12.01.2017 | 47