n When selecting personnel, ensure that the personnel can work
with the control unit in terms of technical and content aspects.
2.3 Intended use
The control unit is exclusively intended and built for the use
described in this installation manual.
The control unit is to be used exclusively to control CNC machines
of a supported number of axes which are in accordance with the
types cleared by Power Automation. Prerequisite for the intended
use of the control unit is proper configuration as described in the
installation manuals provided by Power Automation.
WARNING!
Beware of unintended use!
Any use exceeding the scope of intended use
and/or different application of the control unit can
result in hazardous situations.
– Operate the control unit as intended only.
– Observe all instructions in this installation
manual.
– Observe the permissible ambient conditions
and electromagnetic compatibility mentioned in
the technical data.
Claims of any kind for damage resulting from unintended use are
void.
The operator is solely responsible for all damage resulting from
unintended use.
Intended Use
Dangers
PA 8000 PAMIO
Safety
12.01.2017 | 13
To Next Page
Loading...
Need help?
General
