A-Series Hardware Guide 3-1
CHAPTER 3
Basic Hardware Components
Camera Mounting
The PPT A-Series camera should be fastened to a stable, solid surface so the camera body is well supported.
Warning: There are no user-serviceable parts inside the PPT device. To avoid electrical shock, never open the case.
Avertissement: Il n'y a aucune partie utilisateur-utile à l'intérieur du dispositif d'impact. Pour éviter le choc élec-
trique, n'ouvrez jamais la valise.
This equipment is to be powered by a Listed power supply for the U.S. and Canada, or a power supply that meets the
requirements for use where either IEC60950 or EN60950 is applicable.
• To ensure safe operation, the system power must be properly grounded. If the unit is mounted within a rack, verify
that it is reliably connected to electrical ground. The ground terminal on the +24V power input must be connected
to the grounded chassis/enclosure of the power supply. This insures electromagnetic compliance and proper opera-
tion.
To Next Page