EasyManua.ls Logo

PPT Vision A-Series - Safety Precautions

Default Icon
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When Your System Arrives PPT VISION, Inc.
2-2 A-Series Hardware Guide
Optional LED Ringlight cable (PPT Part # 606-0614-xx)
Optional LED Ringlight adapter (PPT Part # 651-0131)
Optional Dust Cover adapter (PPT Part # 651-0160)
To configure the camera, a computer running the Impact Software Suite Utilities software is required. See Chapter 6 of
this manual and refer to the Impact Reference Guide for more details.
Note: An optional power supply is available for your A-Series camera. If you provide your own, it must supply 24 VDC
@ .50 A (minimum). Its safe operating ambient temperature range is 0° to +50° C (+32° to +122° F).
This equipment is to be powered by a Listed power supply for the U.S. and Canada, or a power supply that meets the
requirements for use where either IEC 60950 or EN60950 is applicable.
Safety Precautions
Warning: There are no user-serviceable parts inside the PPT device. To avoid electrical shock, never open the case.
Opening the case or removing the tamper-proof sticker will void the product warranty.
Avertissement: Il n'y a aucune partie utilisateur-utile à l'intérieur du dispositif d'PPT. Pour éviter le choc électrique,
n'ouvrez jamais la valise. L'ouverture de la valise ou l'enlèvement de l'autocollant de trifouiller-preuve videra la
garantie de produit.
1. Read all of the following instructions before setting up your system. Save this document for later use.
2. Follow all warnings and instructions in this manual and in other user guides shipped with your camera.
3. To avoid damage to your camera and its components, never plug in or unplug a cable when the power is on.
Always shut off the power supply first, then make any necessary cable changes.
4. Never use the system if a power cable has been damaged. Do not allow anything to rest on a power cable and keep
these cables away from traffic.
5. Do not expose your PPT camera to moisture, rain, or snow, and do not use it near water. If a component gets wet,
unplug it and do not use it.
6. To avoid injury, never open the case. Opening the case will void the product warranty.
Service Personnel Only - Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to battery makers instructions.