ID Description
Power Entry Assembly Bracket
Power Cord Inlet Assembly
ON/OFF SW Circuit Breaker
ASL PCA
ASL PCA Bracket
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
TIP: For easier access, raise the incline to maximum before removing power. Access
the service Hardware Validation (51765761) and use the CROSSRAMP/INCLINE
Test to raise the incline and then remove power.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 93
6 Replacement Procedures
ON/OFF SW Circuit Breaker Replacement
To Next Page
Loading...
