Replacement Procedure
Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
2. Remove the hood cover, see "Hood Cover Replacement" on page72.
3. Facing the front of the treadmill, remove the two right side 5/16" hex fasteners and then
loosen the two left side 5/16" hex fasteners (approximately, 4 full turns). Slide the MC
base to the right to remove. Retain part(s) and/or fastener(s) for installation.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 109
6 Replacement Procedures
Motor Controller (MC) Replacement
To Next Page
Loading...
