Precor Experience 700 line Series - Drive Belt Replacement; About; Procedure

Drive Belt Replacement
About
This procedure provides instruction to remove and install the Drive Belt
Procedure
Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
2. Remove the hood cover, see "Covers and Panels Replacement" on page70.
3. Remove the left and right trim landing covers, see "Trim Landing Covers Replacement"
on page75.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 117
6 Replacement Procedures
Drive Belt Replacement