o
If YES, overloading is the most frequent cause of making the treadmill shut down.
Overloading most often occurs when heavy exercisers are running on a worn
belt. Tne deck/belt friction issue is also worsened by poor input line voltage. Over-
loading is often accompanied by error codes 27, 28, or 29. Verify the running belt
condition.
See Also
"System Troubleshooting Procedures" on page181
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 185
7 Troubleshooting
System Troubleshooting Procedures
To Next Page
Loading...
