a. If not, go the Hand Held HHHR troubleshooting procedure to fix the problem.
b. If yes, continue procedure.
2. Verify the wireless heart rate function using a known good chest strap transmitter or test
transmitter. If the heart rate reading is erratic, incorrect, or absent, continue.
Note: It may be necessary to temporarily move closer to the console to allow the
receiver to acquire the heart rate transmitter signal.
3. Identify possible sources of wireless signals that are transmitting in close proximity to
the machine that may cause HHHR transmitter signal interference. Possible types of
products that can cause signal interference include:
l Wi-Fi
1
Network Routers
l Cordless Telephones
l Cell Phones
l Electronic Dog Fences
l Garage Door Remotes
l Florescent light ballasts
4. Power OFF any possible sources of signal interference while using the wireless HHHR
chest transmitter and note if the problem is fixed.
a. If yes, either do not use that device or move it far enough away from the machine
so that it does not interfere with the wireless HHHR transmitter.
b. If NO, continue procedure.
5. If the preceding procedures do not correct the problem, replace the heart rate HHHR
PCA board.
See Also
"System Troubleshooting Procedures" on page181
1
Wireless Fidelity - a term defined and Trademarked by the Wi-Fi Open Alliance. Wireless
LAN equipment carrying the Wi-Fi logo have been interoperability tested for compatibility with
one (or more) 802.11 standards, and certified by the Wi-Fi Alliance to be sold under the Wi-Fi
brand.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 200
7 Troubleshooting
System Troubleshooting Procedures
To Next Page
Loading...
Need help?
General