Precor SPINNER CHRONO POWER User Manual

2. Use a 21 mm open end wrench to loosen the Fixed Nut Bushing while lifting the Brake
Rod Assy and Resistance Knob from the bike frame.
Note:The bushing at the end of the brake rod may catch on the caliper preventing
the rod from being lifted out of the frame weldment. If this occurs, the caliper will
need to be removed to extract the brake rod assembly, "Brake Caliper Assembly
Replacement" on page57.
Installation Instructions
3. If the brake caliper was removed to extract the brake rod assembly, reinstall the cal-
iper, see "Brake Caliper Assembly Replacement" on page57.
4. Before installing the brake rod assembly, make sure that the brake rod plastic bush-
ing is fully inserted into the frame weldment.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 130
5 Replacement Procedures
Resistance Knob Replacement

Precor SPINNER CHRONO POWER Specifications

General

Brand	Precor
Model	SPINNER CHRONO POWER
Category	Exercise Bike
Language	English