6. Tighten the Brake Rod Assy - Fixed Nut Bushing.
7. Set the resistance to minimum.
8. Start pedaling the bike greater than 55 rpm while increasing the resistance level to
maximum and returning to minimum resistance.
l
Verify smooth resistance operation from minimum to maximum levels.
l
Verify that at maximum resistance, the pedal resistance was very strong.
l
Verify that there were no unusual noises from the brake pads during this oper-
ation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 132
5 Replacement Procedures
Resistance Knob Replacement
To Next Page
Loading...
Need help?
General
