5. Reinstall the replacement seat slider in reverse order.
6. Verify the seat slider forward/reverse travel is smooth and is blocked from sliding off
the seat post.
7. Verify that the seat fwd/rev adjustment knob works properly and return to service.
Seat post replacement instructions
1. Pull the seat height adjustment pop-pin and remove the seat post from the frame.
1. Reinstall the seat post by pulling the height adjustment pop-pin and inserting the post
into the bike frame. Release the pop-pin so that it engages into the seat post hole.
2. Verify that the seat height adjustment works properly and return to service.
See Also
"Replacement Procedures" on page41
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 135
5 Replacement Procedures
Seat Assembly Replacement
To Next Page
Loading...
Need help?
General
