4. Remove the strain gauge cable from the inside of the right fork frame weldment.
a. Attach a cable puller (or fish tape) to the strain gauge cable LPCA connector.
b. Then grasp the strain gauge cable (and attached cable puller) at the right fork
weldment upper cable access hole and gently pull the cable from the inside of
the right fork weldment. Stop pulling when the cable puller exits the upper cable
access hole. Disconnect the cable puller from the strain gauge cable leaving
the cable puller inside the right fork weldment. The cable puller will be used to
reinstall the strain gauge cable.
IMPORTANT: Attach a cable puller (or fish tape) to the LPCA connector
end of the strain gauge cable before removing from the inside of the fork
frame weldment. The cable puller will be used to reinstall the cable through
the frame.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 62
5 Replacement Procedures
Brake Caliper Assembly Replacement
To Next Page
Loading...
Need help?
General
