Precor SPINNER CHRONO POWER User Manual

washers (2x). For Spinner® Chrono™ Power models, install the caliper
assembly so that the strain gauge is located on the left side of the frame.
b. Make sure that the resistance rod end bushing is seated over the caliper
assembly plate screw and fully tighten the fasteners.
Note:Make sure that the resistance knob rod end bushing is seated over the cal-
iper plate screw.
2. Reinstall the flywheel, see "Drive Belt, Generator Belt, and Flywheel Replacement"
on page85.
3. Replace the front and rear belt guard covers, see "Belt Guard Cover Replacement"
on page47
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 70
5 Replacement Procedures
Brake Caliper Assembly Replacement

Precor SPINNER CHRONO POWER Specifications

General

Brand	Precor
Model	SPINNER CHRONO POWER
Category	Exercise Bike
Language	English