Installation
1. Reinstall the Data COMM cable through the inside of the right fork weldment and out
the top of the handlebar post weldment.
a. Attach the Data COMM cable - LPCA connector to the previously installed
cable puller exiting the top of the handlebar post weldment.
b. Grasp the cable puller at the lower cable access hole and gently pull the cable
puller downward through the inside of the handlebar post weldment and right
fork weldment exiting though the lower right fork weldment cable access hole.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 78
5 Replacement Procedures
Data COMM Cable Replacement
To Next Page
Loading...
