7
USB. The USB port is for use with the included USB Wi-Fi module when connecting
your StudioLive RM AI-series mixer to a wireless network and controlling it remotely
using UC Surface, and QMix-AI.
It can also be used for installing firmware updates.
Recallable Microphone Inputs. Your StudioLive RM mixer is equipped with 32/16
PreSonus recallable XMAX microphone preamplifiers for use with all types of
microphones.
Each of these solid-state preamplifiers has a Class A input buffer, ultra-low noise,
and wide gain control, allowing you to boost signals without increasing unwanted
background noise.
48 Volt Phantom Power. These inputs also provide 48V phantom power for the
microphone input on each channel, when activated. This feature can be individually
enabled for each channel, using the UC Surface touch control software.
WARNING: Phantom power is required for condenser microphones but can
severely damage some dynamic mics, especially ribbon mics. Therefore, switch
phantom power off for all channels where it is not required.
Power User Tip: Dynamic and ribbon microphones are generally lower-
output devices that require no external power source. In fact, unless a ribbon
microphone calls specifically for phantom power, sending phantom power
to it can cause severe damage. Condenser microphones are generally more
sensitive than dynamic and ribbon microphones and typically require external
+48V phantom power. Always review your microphone’s documentation
to ascertain the manufacturer’s recommended operating practices.
XLR connector wiring for phantom power:
Pin 1 = GND Pin 2 = +48V Pin 3 = +48V
Line Outputs. StudioLive RM32AI offers 16 XLR line outputs and the RM16AI offers 8
XLR line outputs that are fixed to the aux mixes and mirrored on the rear panel with
DB25 output connectors.
To Next Page
Loading...
