47
Load Button. This button loads a preset that
you’ve chosen from the Preset List.
Audition Button. This lets you audition (try out) a preset before loading it
and overwriting the current settings. While in Audition mode, selecting a
preset will immediately change the FX settings to reflect the preset. If you
like what you hear, press Load to write the preset to the channel. If you
want to change a setting, simply change it in the effect and then press load
to load the preset with your changes. If you don’t like what you hear, press
Audition again to exit Audition mode and return to you previous FX settings.
Preset List. This displays the current or active preset
and provides a list of other available presets.
5.8 Working With Presets
To help simplify things, UC Surface uses common workflows
for saving, loading, auditioning, and copying Fat Channel,
FX, and graphic EQ presets, as described below.
Saving Presets
To save a preset:
1. Select the preset slot to which you would like to save.
2. Click or tap the Add Preset button (+).
Loading Presets
To load a preset:
1. Select a preset from the Preset List.
2. If you’re loading a Fat Channel preset, and you want to prevent
the current noise gate, compressor, or EQ settings from being
changed, click or tap the corresponding Micro View button.
3. Click or tap the Load Preset button.
Auditioning Presets
To audition a preset:
1. Click or tap the Audition button.
2. Select the preset you would like to audition.
You can exit Audition mode by doing one of the following things:
A. Clicking or tapping the Audition button again. This returns
the parameters to their “pre-Audition” values.
B. Clicking or tapping the Load button. The Audition button
is deactivated, and the Preset will be loaded.
Copying and Pasting Presets
To copy and paste a preset:
1. Click or tap the Copy button.
2. If you’re copying a Fat Channel preset, and you want to prevent
the current noise gate, compressor, or EQ settings from being
pasted, click or tap the corresponding Micro View button.
3. Select a destination channel for the copied preset by clicking
or tapping the Previous or Next button or by selecting
another channel from the Channel Selection list.
4. Click or tap the Paste button.
5. Repeat steps 3 and 4 as needed.
To Next Page
Loading...
