Why is there ink mixing in my Printing Innovation iCUBE 1 Label Maker?
Ink mixing in the Printing Innovation Label Maker can stem from ink flooding, air present in the printhead, or a dirty printhead. To resolve this, try automated servicing or manual wiping.
What to do if the motor stalls on Printing Innovation iCUBE 1 Label Maker?
If the motor stalls in your Printing Innovation Label Maker, it could be due to a jammed gear train from a broken post or improperly seated gears, a wedged or improperly seated squeegee, debris buildup on the blade and rollers, or a bad motor. First, check each of these possible causes and correct them if possible by reseating gears and the squeegee or cleaning debris from the blade and rollers. Then, re-test the motor. If it remains stalled, contact Customer Service.
Why is my Printing Innovation Label Maker color mixing?
Color mixing in the Printing Innovation Label Maker can occur if the wiper roller (microfiber roller (MFR)) is saturated or if the squeegee (doctor blade) is wedged, not seated properly, or bowed. If the wiper roller is saturated, replace it. If the squeegee isn't seated correctly, reseat it. If the squeegee is bowed, contact Customer Service.
How to fix air bubbles in Printing Innovation Label Maker?
Air and air bubbles causing blocked nozzles in the Printing Innovation Label Maker can be addressed through recirculation, priming, or cycles of depriming and repriming. Often, the bubbles will disappear over time.
What to do if Printing Innovation iCUBE 1 Label Maker has electrical failure?
If you're experiencing an electrical failure or poor electrical connection with your Printing Innovation Label Maker, try reseating or replacing the printhead.
How to clean debris from Printing Innovation Label Maker printhead?
Debris on the printhead of the Printing Innovation Label Maker can be cleared by automatic servicing or manual wiping.
General| Brand | Printing Innovation |
|---|---|
| Model | iCUBE 1 |
| Category | Label Maker |
| Language | English |
To Next Page