PRO AIR TPK 21 - Page 4

Table of contents
11.
Configuration of Alarm Output
84
11.1.
Setting of desired alarm value 1
85
11.1.1.
Setting of desired measurement - channel (source)
85
11.1.2.
Setting Pre-alarm
87
11.1.3.
Setting Main-alarm
92
11.1.4.
Setting delay
97
11.2.
Setting of desired alarm value 2
99
12.
Technical Datas
100
12.1.
Dimensions
102
13.
Modbus
103
13.1.
Supported MODBUS features
103
13.2.
Supported MODBUS commands
103
13.2.1.
Function code 3 - Read Holding Registers
104
13.2.2.
Function code 17 - Report Slave ID
104
13.2.3.
Function code 1 - Read coils
104
13.2.4.
Function code 5 - Write single coil
104
13.2.5.
Function code 6 - Write single register
105
13.2.6.
Function code 16 - Write multiple register
105
13.2.7.
Exceptions returned
105
13.3.
Holding registers memory mapping
105
13.3.1.
General Holding registers mapping
106
13.3.2.
Project specific Holding registers mapping
109
13.4.
Coil address memory mapping
109
13.4.1.
General Coils mapping
109
13.4.2.
Project specific coils mapping
109
14.
Data logging
110
15.
Appendix
113
15.1.
Menu structure
114
15.1.1.
Menu item: Main
114
15.1.2.
Menu item: Out
115