11.1.3 Setting Main Alarm
Once the desired measuring channel and pre-alarm have been set, the desired value for the
"Main Alarm" can be set.
1. To do this, select „Main Alarm“ field (highlighted) and confirm with „Enter“ .
This brings you to the following setting menu:
This menu item can be confirmed with
„Yes“ or „No“ by selecting the field in the
following screen.
Defines whether Main Alarm 1 must be acknowledged or automatically turns itself
off in the event of a limit violation.
This menu item allows you to configure the upper limit value for Main Alarm 1.
This menu item allows you to configure the lower limit value for Main Alarm 1.
To Next Page
Loading...