8.10 Measurement Value Simulation
This menu item is used to test the relay and alarm functions. Measured values can be
simulated in order to test the switching characteristics of the outputs.
This menu item enormously facilitates initial start-up, since it is not necessary to set real
conditions in the compressed air system in order to check the correct settings.
There is therefore no interference with operation
The procedure is as follows:
1. Select one of the three segment fields (the background turns dark and control keys appear
at the bottom of the display).
The following display appears:
3. Enter your personal PIN code (if it has already been changed). If the device is
still in its factory settings, key in 111111.
To Next Page
Loading...