PRO AIR TPK 21 - Page 55

50
Two choices appear („UMC Channel“ und „Set Value“)
10. If the „UMC Channel“ field is not already highlighted, select the field and
confirm with .
12. A list appears of all of the measurement parameters for which a measured value can
be simulated.
Scroll up or down using the "Scroll-down" and "Scroll-up" keys until you find
the Relay and Alarm output value that you wish to test.
None
System Pressure
A. Pressure
Temperature
Rel.Humidity
Dew-/ Frostpoint
ppm Volume
A. Humidity
10
11
UMC Channel
Set Value
None
System Pressure
A Pressure
Temperature