2-6
Installing the Access Point
Installation Procedures
c. Connect to the Web Interface and Change the IP Address
1. Start your Web browser.
2. In the address or location bar, enter http://192.168.1.14. The logon dialog
box appears.
3. In User Name, type admin.
4. In Password, type password. The Web interface appears, showing the
Information page.
5. On the menu, click Basic Settings.
6. Configure the IP address settings.
• (Recommended) If you want to assign a fixed IP address to the access
point, select Disable in DHCP Client, and then enter the IP Address,
IP Subnet Mask, and Default Gateway that you want to assign to it.
These settings must be compatible with your network to ensure that
the access point can communicate with other network devices.
• If you have a DHCP server on the network and you want the access
point to automatically obtain an IP address from the DHCP server,
click Enable in DHCP Client. You do not have to configure other
settings, but you will need to check the DHCP server periodically to
determine the IP address that the access point is using.
7. In Country/Region, select the country/region where you are operating
the access point.
Note You must select the correct country/region for the location in which you
operate the access point, so that it uses only the authorized radio channels for
wireless network devices.
8. Click Apply.
You have completed configuring your access point's IP address settings so
that it can work on your network. Remember to return your computer's IP
address settings to its original settings.
Disconnect the access point from the management computer. You are now
ready to find a suitable location for the access point and to connect the access
point to the network.
To Next Page
Loading...