Prodigit 3270 Series User Manual

114 PRODIGIT
BIT ID
BIT VALUE
REMARK
bit 0
0 = Off, 1 = Triggered
Over Power Protection (OPP)
bit 1
0 = Off, 1 = Triggered
Over Temperature Protection (OTP)
bit 2
0 = Off, 1 = Triggered
Over Voltage Protection (OVP)
bit 3
0 = Off, 1 = Triggered
Over Current Protection (OCP)
Table 4-10 register of PROT status
[STATe:] NGEABLE {ONOFF}
Syntax: [STATe:] NGEABLE {ONOFF} {;NL}
Purpose:To set the GO/NG check function enable or disable.
Description:To set the function of NG judgment opens when POWER ON. When setting
for POWER OFF, the function of NG judgment will not be implemented.
[STATe:] START
Syntax: [STATe:]START {;NL}
Purpose:Set for Load to implement the test.
Description:Set for Load to implement the test, and according to TEST CONFIG
(TCONFIG), the Load will start to test the items and parameters which are
Required
[STATe:] STOP
Syntax: [STATe:] STOP {;NL}
Purpose:Set for Load to stop the test
Description:Set for Load to stop the test
[STATe:] TESTING?
Syntax: [STATe:]TESTING {?} {;NL}
Purpose:Check whether the current electronic load is in the test state.
Description:Check whether the current electronic load is in the test state, 1: testing 0:
Test end.
Example: START
TESTING?
NG?
STOP
[STATe:] SYNCronize
Syntax: [STATe:]SYNCronize {SP}{ONOFF} {;NL}
[STATe:]SYNCronize {?} {;NL}
Purpose:Load sync signal.
Description:Electronic load sync signal,1: SYNC ON 0: SYNC OFF。
4.7.4. SYSTEM Set and Read the Status of 3270 Series
[SYStem:] RECall{ SP }m{ ,n }
Syntax:[ SYStem:] RECall{ SP }m{;NL}

Prodigit 3270 Series Specifications

General

Brand	Prodigit
Model	3270 Series
Category	Measuring Instruments
Language	English