Prodigit 3350F Series User Manual

3350F Series Operation Manual 87
OPP: STOP
Syntax： [PRESet：] OPP:STOP {SP}{NR2}{；NL}
[PRESet：] OPP:STOP ？ {；NL}
Purpose：Set and read the maximum value of OPP test
Description：This command is used for setting the maximum value (P-STOP) of OPP
test
TCONFIG
Syntax： [PRESet：] TONFIG {NORMAL|OCP|OVP|OPP|SHORT}{；NL}
[PRESet：] TONFIG ？ {；NL}
Purpose：Set and read the function of Dynamic test
Description：There are four options of this command. Those are NORMAL mode、
OCP test 、OPP test and SHORT test.
STIME
Syntax： [PRESet：] STIME {SP}{NR2}{；NL}
[PRESet：] STIME ？ {；NL}
Purpose：Set and read time of the short-circuit test
Description：This command is used for setting time of the short-circuit test. If time set
to 0, it means that have no the time limit and continue to be short –
circuited. The unit is milli-second (ms)
OCP
Syntax： OCP？
Purpose： Set read OCP testing current.
Description： This command is used for setting OCP test read OCP current.
OPP
Syntax：OPP？
Purpose：Set read OPP testing watt.
Description：This command is used for setting OPP test read OPP watt.
4.6.2. LIMIT Set and read the top and bottom of the Load judgment NG limit
[LIMit
：
]CURRent
：
{ HIGHLOW} or IHIL
Syntax： [LIMit]：CURRent：{ HIGHLOW}{SP}{ NR2 }{；NL}
[LIMit]：CURRent：{ HIGHLOW} ？{；NL}
[IHIL]{SP}{ NR2 }{；NL}
[IHIL} ？{；NL}
Purpose：To set the upper/lower limit value of threshold current.
Description：This command is to set the lower limit value of threshold current. When
load sink current is lower than this lower limit value or higher than the
upper limit value, NG indicating light will come on to indicate 〝NO
GOOD〞.

Prodigit 3350F Series Specifications

General

Brand	Prodigit
Model	3350F Series
Category	Power Supply
Language	English