4.11.1 Quick configuration of the locking mechanism
From version 7r75 onwards, the software enables quick configuration of lock parameters (lock type and its voltage).
Configurator is launched by program A-0, subprogram 98. Using a single entry, the cassette sets the parameters:
400 (filling PWM of lock at idle)
401 (filling PWM of lock at first phase)
402 (filling PWM of lock at second phase)
403 (filling PWM of lock at third phase)
Lock configurations are entered using a four-digit number. The following digits are described below:
• first digit → keyboard number (0 – global setting)
• second digit → type of locking (0 – regular, 1 – reverse)
• third and fourth digits → filling in (as a percentage) (see point 7.4.1)
Examples of prepared numbers:
- 0050 – global setting, normal locking, filling 50% in the second phase of control
- 0170 – global setting, reverse locking, filling 70% at idle
- 5080 – local setting for keyboard 5, normal locking, 80% filling in the second phase of control
- 5000 – deletion of local PWM settings of the lock for keyboard no. 5
To Next Page
Loading...