Need help?Do you have a question about the Proma MyPlasm CNC and is the answer not in the manual?
Protective earthing to discharge plasma arc potential. Avoid ground loops.
Controller's emergency stop input interrupts operation. Auxiliary contacts for power cut-off.
Instructions for downloading and installing the MyPlasm CNC software and drivers.
Connecting the 24V DC power supply and USB cable; checking communication status.
Connecting stepper motor drivers using STEP/DIR signals, using twisted pairs.
Setting the correct direction of movement for each axis in the software.
Setting gear ratios to translate motor rotation into axis movement.
Setting motor micro-stepping division to match software and driver configuration.
Testing axis configuration by moving and comparing screen coordinates with actual displacement.
Adjusting maximum speed, hand speed, safety speed, and acceleration for optimal performance.
Testing machine dynamics in simulation mode without plasma activation.
Wiring PNP/NPN sensors and mechanical limit switches to the controller inputs.
Configuring homing direction, speed, and testing the XYZ reference procedure.
Connecting the plasma interface module via RS485 bus; shield connection.
Activating arc ignition using the SPACE key or torch symbol button.
Measuring plasma arc voltage for torch height control; understanding voltage dividers.
Configuring plasma interface multiplier, voltage divider, and THC settings.
Performing a manual cut test to read and verify ARC voltage for THC.
Mechanical height detection using a torch on an additional guide.
Electrical circuit system for height detection based on contact with material.
Combining systems for enhanced reliability and fault tolerance.
Setting area limits for detection to avoid repeated measurements.
Function for centering holes for subsequent drilling or marking.
Counters for tracking operation time and number of piercing operations.
Configuring auxiliary outputs for external devices like relays.
Assigning functions like HOME, ARC OK, or Start/Stop to input terminals.
Using a laser pointer for material positioning and referencing before cutting.
Function for engraving or scribing text/graphics on material.
Setting delay for automatic operation start for external equipment.
Enabling gas cutting with preheating options for pond formation.
Enabling milling operations with options for depth and grooving.
Adjusting THC response speed for deformed materials or corrugated sheeting.
Information regarding support for rotary axis functionality (BETA version).
System retry mechanism if no main arc is detected.
Testing for mechanical backlash in axes by small movements.
Creating a new profile for specific cutting tasks or configurations.
Location of configuration data and profile files; editing logo graphics.
Securing system configuration and profiles with a password.
General| Brand | Proma |
|---|---|
| Model | MyPlasm CNC |
| Category | Control Systems |
| Language | English |
To Next Page