Tab. 1: Identifier and error displays:
Identifier Meaning
The pump is working or waiting for a starting signal.
The pump was manually stopped using the
[STOP/START]
key.
The pump was remotely stopped (Pause) - via the "External" socket.
The pump was stopped by an error.
Only with cyclical batch metering: the pump is waiting for the next cycle.
‘memory’
Only in
‘CONTACT’
and
‘BATCH’
operating modes:
The "Stroke memory" auxiliary function has been set.
The pump is in
‘ANALOGUE’
operating mode.
The
‘Curve
è
linear’
type of processing is set.
The pump is in
‘ANALOGUE’
operating mode.
The
‘Curve
è
Upper side band’
type of processing is set.
‘AUX’
The pump is currently pumping at auxiliary capacity and/or auxiliary frequency.
The diaphragm rupture warning system is disabled.
A "Flow Control" metering monitor is connected.
The timer is active.
Only with
‘Password’
: the pump software is locked.
Only with
‘Password’
: the pump software has been temporarily unlocked.
The pump is in the
‘Menu’
(Set up).
Further explanations can be found in the "Trouble‐
shooting" chapter.
Overview of equipment and control elements
16
To Next Page
Loading...
Need help?
General
