ProMinent S3Cb - System

9.3.4.5
‘Flow control’
‘Menu / Information è Settings è Inputs/outputs è Flow control
è ...’
The setting options for the ‘Flow control’ function are
only available if a flow control is electrically installed. The
symbol for flow control appears:
.
A metering monitor, such as a Flow Control (also DulcoFlow
®
), can reg‐
ister the individual pressure impacts of the pump and report them back to
the pump.
It is possible to switch the function on and off under
‘Activation’ .
The pump switches to fault mode if this feedback isn't provided a certain
number of times in succession as set under ‘Tolerance / strokes’ .
Under ‘at Auxiliary’ , it is possible to set whether the function is to be deac‐
tivated with auxiliary frequency.
Under ‘Signalling’ , you can set whether the control is to trigger an error or
a warning when the tolerance is exceeded.
9.3.4.6 ‘Diaphragm rupture’
‘Menu / Information è Settings è Inputs/outputs
è Diaphragm rupture è ...’
The setting options for the ‘Diaphragm rupture’ function
only exist if a diaphragm rupture indicator is electrically
installed. The symbol for diaphragm appears
.
In the ‘Diaphragm rupture’ sub-menu you can select whether the pump
generates a warning message or an error message in the event of a dia‐
phragm rupture.
9.3.5
‘System’
‘Menu / Information è Settings è System è ...’
The ‘System’ menu splits into the following sub-menus:
1 - ‘Bluetooth’
2 - ‘Volume unit’
9.3.5.1 ‘Bluetooth ’
‘Menu / Information è Settings è System è Bluetooth è ...’
You can switch the pump’s Bluetooth communication on and off in the
‘Bluetooth’ sub-menu. The blue “Bluetooth active” LED lights up on the
HMI.
Set up /
‘Menu’
55