9.3.5.2
‘Volume unit’
‘Menu / Information
è
Settings
è
System
è
Volume unit
è
...’
You can select another unit for the volume in the
‘Volume unit’
sub-menu.
9.3.6
‘Set time’
‘Menu / Information
è
Settings
è
Set time
è
...’
You can set the time in the
‘Set time’
menu.
1. Use the dial to adjust a figure.
2.
Use
[Priming]
to move to the next figure.
Under
‘Auto. Summertime’
you can select whether you wish to change
over to
‘Summertime’
.
You can also input when the pump is to change to and from
‘Summertime’
.
Check under
‘Location’
whether the pump is also set to its own
‘hemisphere’
of the world.
9.3.7
‘Date’
‘Menu / Information
è
Settings
è
Date
è
...’
You can set the date in the
‘Date’
menu.
9.4
‘Timer’
‘Menu / Information
è
Timer
è
...’
The process timer can do the following to the pump at a predefined time:
n start
n stop
n change operating mode
n open the relay (with "CTRL software" higher than 01.01.03.01)
n close the relay (with "CTRL software" higher than 01.01.03.01)
9.4.1 Timer
‘activation’
‘Menu / Information
è
Timer
è
Activation
è
...’
To activate the timer, set
‘Activation’
to
‘active’
.
9.4.2
‘Setting the timer’
‘Menu / Information
è
Timer
è
Set timer
è
...’
You can create commands (program lines) for a timer program in the
‘Set
timer’
menu.
You can create up to 32 commands (program lines).
Set up /
‘Menu’
56
To Next Page
Loading...
