Protec PRS 500 E - Inspection and Maintenance; Daily Monitoring before and During the Examination Operation; Regular Monitoring; Maintenance

PRS 500 E Instructions for use
5069-0-8002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany 31 von 47
For disinfection of surfaces in contact with patients, we recommend commercially available medical
rapid disinfection wipes (e.g. Dr. Schumacher Descosept Sensitive Wipes).
All mechanical parts of the PRS 500 E, including accessories, may only be cleaned with a wipe
disinfection with suitable surface disinfectants (e.g. Melsept® SF, 15 min. application time at 2%
concentration). The information provided by the disinfectant manufacturer on concentrations and
application times must be observed.
WARNING!
No highly flammable disinfectants may be used! For safety reasons, spray
disinfection must not be carried out, as the spray mist could penetrate the
device and cause short circuits or corrosion.
If disinfectants are used that can form explosive gas mixtures, the device may
only be switched on again when the gas mixtures have evaporated!
5.4 Inspection and maintenance
WARNING!
No maintenance or repair work may be performed while the PRS 500 E is
being used with a patient!
All maintenance and repair work may only be performed by personnel trained
or authorized by PROTEC.
5.4.1 Daily Monitoring before and during the Examination operation
See instructions for use of the associated system components.
Wear parts must be replaced with original components.
5.4.2 Regular Monitoring
See Instructions for use of the associated system components.
Wear parts must be replaced with original components.
5.4.3 Maintenance
The required maintenance must be carried out by PROTEC service department or a service company
authorized by them in order to ensure the safe and reliable functionality of the device. The
maintenance intervals depend on the frequency of use. The required specifications can be found in the
corresponding Technical Description in chapter 3 Maintenance and Safety Inspection.
In the event that the planned maintenance is not carried out, PROTEC GmbH & Co. KG assumes no
liability whatsoever for damage to the user and third parties if damage results from inadequate or not
carried out maintenance.
Prior to the examination operation, the user must satisfy himself that all appliances listed in the
operating instructions and serving safety are in working order and that the product is ready for
operation.
See the technical descriptions of the X-ray system and the associated system components.
Wear parts must be replaced with original components.
5.4.4 Warranty
NOTE
You will find the current warranty conditions in your order documents or in the
price list valid at the time of purchase.
Repairs and spare parts in the event of improper use are also excluded.