Protec PRS 500 E - Safety Instructions

PRS 500 E Instructions for use
5069-0-8002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany 13 von 47
2 Safety Instructions
NOTE
Contains information that must be observed during operation.
xxx
CAUTION!
Contains information which, if not observed, can cause property
damage.
xxx
WARNING!
Contains information which, if not followed, can cause personal
injury.
xxx
WARNING!
Warning of radioactive substances or ionizing radiation. Contains
information which, if not observed, can cause personal injury.
xxx
Settings and calibrations that are not described in these instructions for use must be carried out using
the technical description of the device by PROTEC service department or a service company authorized
by them.
NOTE
All instructions supplied with the PRS 500 E must be observed and the safety
instructions contained therein must be carefully read and adhered to.
NOTE
After the initial installation, the commissioning must be recorded with the PROTEC
acceptance protocol FB-04-07A4.
NOTE
In the case of a digital system, the instructions for CONAXX and RAPIXX must be
observed and the safety instructions contained therein must be carefully read and
adhered to.
NOTE
The X-ray system may only be commissioned if all safety measures for operator
protection have been met and checked. These protective measures can include
door contact, designated area, dosimeter, protective clothing, etc.