PRS 500 E
Instructions for use
5069-0-8002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany 8 von 47
The system causes different ionising radiation. The purpose is to create
characteristic X-ray radiation. The intensity depends on the adjusted values of
voltage, current and time. The radiation comes orthogonal out of the X-ray
tube and is limited by the collimator.
To the User
NOTE
The user of these accompanying documents is required to carefully read through
and carefully consider the instructions, warnings and cautions contained therein
before starting operation.
Even if you have already operated similar systems, changes in the design,
production and functional routine of the system described here may have been
made, which have a significant influence on the operation.
Although the product was subject to a risk analysis and the design corresponds to
the current state of the art, residual risks remain in clinical use. These are displayed in
the following Instructions for use by application limits, contraindications, warnings
and precautions.
Assembly and service works on the system described here must be carried out by
authorised and qualified personnel from PROTEC GmbH & Co. KG. Assembly
personnel and other persons who are not employees of the technical service
department of PROTEC GmbH & Co. KG are requested to contact the local branch of
PROTEC GmbH & Co. KG before assembly or service work is started.
For assembly and service works, it is necessary to use the "Technical Description” of
the product and to observe the points it contains.
NOTE
The use of the product with add-on or accessory parts not authorized by PROTEC or
other unapproved components is not permitted.
To Next Page
Loading...
