FAQ and Troubleshooting
View the following advices on most frequently asked questions.
About General Tips
1. If the display of TR515/TR510 often shows "BUSY" and the card is not
accepted when you present (swipe) the card to TR515/TR510
TR515/TR510 will show “BUSY” when it is downloading the data. At the
moment, the card won’t be accepted when you present (swipe) the card
to TR515/TR510. If the interval time of auto-download in the software is
set too short, it will cause TR515/TR510 to download the data
automatically quite often. Set the interval time of auto-download longer
to avoid the busy situation.
2. If the display of TR515/TR510 shows “FULL” when you present (swipe)
the card to it
It indicates that the record memory of TR515/TR510 is full. Use the
software to download all the data in TR515/TR510. Then delete the data.
If you like that the data can be erased automatically whenever it is
downloaded successfully by the software TR515 Tool/TR510 Tool, see “7.
If you want the data in TR515/TR510 to be deleted automatically
whenever it is downloaded successfully by using ‘Time Scheduler’” in the
section “About Software (TR515 Tool/TR510 Tool)” of this document.
If you like that the data can be erased automatically whenever it is
downloaded successfully by the software Time Recorder Utility, see “9. If
you want the data in TR515/TR510 to be deleted automatically whenever
it is downloaded successfully” in the section “About Software (Time
Recorder Utility)” of this document.
To Next Page
General