13. Is it possible to run the software TR515 Tool/TR510 Tool and download
the data automatically at an assigned time whenever your computer
boots
See advice in “12. Is it possible to start the software TR515 Tool/TR510
Tool with the scheduled task whenever your computer boots”.
About Software (Time Recorder Utility)
1. If the communication is failed when clicking [Test Connection] in the
software Time Recorder Utility (for RS232 interface type)
Make sure TR515/TR510 is powered on.
Make sure the “Comm. Port” selection in the software is correct.
Change the other computer to try.
2. If the communication is failed when clicking [Test Connection] in the
software Time Recorder Utility (for Ethernet interface type)
Make sure TR515/TR510 is powered on.
Make sure TR515/TR510 is connected with Hub via “WAS-1499” cable.
Make sure the firewall and antivirus program in your computer are
disabled before using the software.
Use the software DS Manager to detect TR515/TR510 first. (Before using
the software DS Manager, disable the firewall and antivirus program in
your computer as well.) Then go back to the software Time Recorder
Utility to test the connection again.
Try the other port of your Hub to connect with TR515/TR510.
Try the other WAS-1499 cable if you have more than one cable.
3. If you want to set TR515/TR510 in the software Time Recorder Utility
Once TR515/TR510 is connected successfully with the software Time
Recorder Utility, click [Download] inspection and then double-click your
TR515/TR510 on the terminal list to launch [TR51x Properties] window
and access the settings of property.
To Next Page
Loading...