If you have set the machine ID for TR515/TR510 in the software TR515
Tool/TR510 Tool, make sure the machine ID is set correctly. It needs the
particular steps to set machine ID. See “Adding new Machine ID”
instruction of the section “Appendix F. Installation” (or “Appendix E.
Installation”) in TR515/TR510 users manual for the correct procedure to
add the time recorder and set its machine ID.
Try the other port of your Hub to connect with TR515/TR510.
Try the other WAS-1499 cable if you have more than one cable.
3. How do you add a time recorder and set its machine ID in the software
TR515 Tool/TR510 Tool correctly
See “Adding new Machine ID” instruction of the section “Appendix F.
Installation” (or “Appendix E. Installation”) in TR515/TR510 users manual
for the correct procedure. It needs the particular steps to add the time
recorder and set its machine ID in the software TR515 Tool/TR510 Tool.
Incorrect steps will cause the connection failed.
4. Why can’t you download the data automatically by using “Time
Scheduler” function after TR515/TR510 is connected successfully with the
software TR515 Tool/TR510 Tool
“000-Default” on [Device List] can’t be used for “Time Scheduler”
function. Therefore, you need to set a machine ID for TR515/TR510 in the
software TR515 Tool/TR510 Tool first in order to use “Time Scheduler”
function to download the data automatically. It needs the particular steps
To Next Page
Loading...