Pulsar Measurement Ultra 3 User Manual

ULTRA 3 INSTRUCTION MANUAL
148
Auxiliary
P810 Units
This parameter determines whether the Measurement units (P104) are
displayed on the auxiliary line of the display in run mode.
OPTION
DESCRIPTION
0 = No
Measurement units will not be displayed
1 = Yes (Default)
Measurement units will be displayed
P811 Alarm Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when an alarm relay is switched
on or off. The message is in the form “Alarm High ON”, where the ‘High’ is
determined by the setting of the relay Alarm ID (P212, 222, 232).
OPTION
DESCRIPTION
0 = No (Default)
Alarm messages will not be displayed
1= Yes
Alarm messages will be displayed
P812 General Control or Pump Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a pump or general control
relay is switched on or off. The message is in the form “General 1 ON”, where
the number displayed is the number of the relay.
OPTION
DESCRIPTION
0 = No (Default)
Pump messages will not be displayed
1= Yes
Pump messages will be displayed
P813 Control Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a control relay is switched
on or off. The message is in the form “Time ON”.
OPTION
DESCRIPTION
0 = No (Default)
Control messages will not be displayed
1= Yes
Control messages will be displayed

Pulsar Measurement Ultra 3 Specifications

General

Brand	Pulsar Measurement
Model	Ultra 3
Category	Measuring Instruments
Language	English