ULTRA 3 INSTRUCTION MANUAL
166
P940 Number of Starts
This parameter shows how many times the unit has been powered up.
P941-P960 Start Date & Time
Parameters P941 and P942 show the date and time that the unit was last
started. There are ten start dates & times recorded, which are parameters
P943-P960. The first on the list are the most recent, and the last ones are
the oldest. These are read only and cannot be changed.
Daylight Saving Time
P970 DST Enable
When Enabled (set to 1) the internal clock will be automatically adjusted to
compensate for the difference between standard time and Daylight-Saving
Time. Default = 1 (Yes)
P971 DST Difference
This parameter sets the time difference between standard time and
Daylight-Saving Time. The time difference is entered in HH:MM.
Default = 01:00
P972 DST Start Time
This parameter is used to set the time of day at which Daylight-Saving
Time will start, the time is entered in the format HH: MM (24-hour format).
Default = 02:00
Important Notice
In order to ensure the correct operation of Daylight-Saving Time P932 Time
should be checked, and adjusted if necessary, to ensure that it is set for the
current valid time.
To Next Page
Loading...
Need help?
General