PULSAR MEASUREMENT
163
System Information
The following three parameters do not affect how the unit performs, but
details, contained in them, may be required, by Pulsar, when making technical
enquiries.
P926 Software Revision
This parameter will display the current software revision. It is read only and
cannot be changed.
P927 Hardware Revision
This parameter will display the current hardware revision. It is read only and
cannot be changed.
P928 Serial Number
This parameter will display the serial number of the unit. It is read only and
cannot be changed.
P929 Site Identification
This parameter allows you to give each unit an individual reference number,
for identification purposes. You can set any number between 1 and 99999.
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested before despatch to you.
To reset parameters, enter 1 (Yes), and press ENTER, then you will see a
message “Entr if sure”, you should press ENTER again. If you press any other
key at this point, the parameters will not be reset, and you will see a
message confirming this.
Once you have done this, program the unit, to the desired application.
To Next Page
Loading...
Need help?
General