PULSAR MEASUREMENT
15
CHAPTER 2 ULTRA 3 INSTALLATION
Unpacking
Power Supply Requirements
Ultra 3 can operate from AC supply or from a DC battery. The AC is either
115V +5%/-10% 50/60Hz or 230V +5%/-10% 50/60Hz, depending on the
position of the selector switch. The DC is 18-30V. In all cases the Ultra 3 will
typically consume 6W of power, with a maximum of 10W.
Important Information
All shipping cartons should be opened carefully. When using a box cutter, do not
plunge the blade deeply into the box, as it could potentially cut or scratch
equipment components. Carefully remove equipment from each carton,
checking it against the packing list before discarding any packing material. If
there is any shortage or obvious shipping damage to the equipment, report it
immediately to Pulsar Process Measurement Limited.
To Next Page
Loading...