Pulsar Ultra 3 (UL) - Page 189

Page 181
P145 Tel. No.1
This parameter is used to enter the number of ‘0’s that appear at the
beginning of the telephone number to be dialled that is to receive the
message.
Option
Description
0= None
No ‘0’s present at the beginning of the
telephone number to be dialled.
1 = Add 0 (Default)
1 ‘0’ present at the beginning of the
telephone number to be dialled.
2= Add 00
2 ‘0’s present at the beginning of the
telephone number to be dialled.
P146 Tel. No2
This parameter is used to enter to enter the next 6 digits, following the ‘0’s,
of the telephone number to be dialled. If there are less than 8 digits
following the ‘0’s then just enter the digits required, if there are more digits
following the ‘0’s then enter the first 6 digits and then proceed to P147 and
enter the remaining digits.
P147 Tel. No3
This parameter is used to enter any remaining digits of the telephone number
to be dialled after completion of P145 and P146 above.
Example
Telephone number to be dialled is: 0 1234 123456
P145 Tel. No. 1 = 1(One ‘0’ at the beginning of the telephone number)
P146 Tel. No. 2 = 123412 (The next 6 digits following the ‘0’s).
P147 Tel. No. 3 = 3456 (Remaining digits of telephone number).
P148 Timed Out
This parameter will set the time period that the unit will wait for a reply
before disconnecting. Default = 90 seconds