Page 85
Chapter 7 Flow
When Ultra Wizard = 3
Ultra 3 is configured as a Flow 3
Quick Setup
This quick set-up guide shows you how to get up and running within a few
minutes of installing your Flow 3.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter this.
Before proceeding ensure that Ultra Wizard = 3 Flow (Flow 3). For further
details see Chapter 4 Ultra Wizard.
Choose Quick Setup
Now you need to go into the quick setup. You will see on the display the
words ‘Ultra Wizard’, press the ‘right hand’ arrow key and this will take you
to the ‘Quick Setup’ menu option. Try pressing either of the two arrow keys
to see some more menu options, but return to Quick Setup, and press
This takes you to the “Quick Setup Menu”.
This takes you to the common applications menu,
and a number of options will appear on the
display.