Page 87
To set-up an application for a device contained in special, choose 5. You
then need to select the primary measuring device for your application from
the following available options: Palmer Bowlus flume, H-flume or a V
notch, other than BS3680.
For devices, which do not match any of the above devices the application
can be setup using a universal flow calculation, to select this option choose
6. You then need to select the primary measuring device for your
application from the following available options: linear flow or curved
flow.
Once you have chosen your application you will be asked a series of
questions which are answered by choosing the appropriate option as detailed
in the flow chart below. Once all the questions have been answered you will
be prompted to provide further information, as detailed in the tables below,
to complete the programming of the unit.
To Next Page
Loading...
Need help?
General
